Returning from the low-magic world, do artificial intelligence first.

Chapter 166 The direction of terror
Wang Yi started a long-term experimental state of overclocking from time to time, and Lin Shiqin was in charge of everything outside, so he could do things cheaply.

The process has never been interrupted.

In fact, after completing the A1 contact lens, Wang Yi has been exploring the magic power to lock the energy level of electrons, so that electrons do not absorb high-energy photons and allow high-energy beams to pass through.

(Here, you can review the second half of Chapter 105. After all, it is on the Science Fiction Channel. It is better to meet some basic ones.)
The research has been going smoothly step by step, and the wavelength of light transmitted by the resin has been around 150nm.

This can be said to be quite an exaggerated achievement!
The current extreme ultraviolet EUV lithography machine is still in ASML's laboratory stage, and perhaps prototypes and prototypes have appeared, but the original purpose of the EUV lithography machine is to mass-produce chips, and it requires a vacuum environment, so whether it is It will take time until the lithography machine can mass-produce chips or until the lithography machine itself is commercialized.

At present, the top lithography machine is the 193nm wavelength immersion DUV lithography machine produced by the cooperation of ASML's corner overtaking and SEMC theory. Because of the use of liquid refractive index, the precision of the deep ultraviolet wavelength limit of 193nm can be greatly increased. .

Although the current general chip technology is still above 20nm, the theoretical precision of the immersion DUV lithography machine can reach the limit of 7nm, but to achieve this, a supporting process is required, and not everyone can achieve it.

Connie and Canon, the lithography machine giants in the past, have always used dry lithography machines and only wanted to shorten the wavelength of the light source. Even if they produced a 157nm wavelength lithography machine, they were still overtaken by ASML's ruthless curve, thus losing customers.

This is cutting-edge technology, winner takes all!

However, even if the DUV lithography machine is only deep ultraviolet, it is quite scarce to choose a lens. The available options are probably calcium fluoride and barium fluoride.

The photon energy level of deep ultraviolet light is too high, and it is too easy to be absorbed. This is light that cannot even enter the ozone layer. Resin and other things are a bit of a fantasy.

But before Wang Yi relied on magic power to bless the electrons in the resin, he forced it to the point where the wavelength of 150nm could pass.

Theoretically, taking this thing out can already make the scalps of companies like Carl Zeiss numb, and even upgrade the current version of the lithography machine to a certain extent.

It's just that Wang Yi is still quite dissatisfied with this.

He uses magic technology, and it is so difficult to reach the limit of 150nm. In the future, the EUV lithography machine will be close to the X-ray critical value of 13.5nm, and the photon energy level will be ten times higher than the 150nm deep ultraviolet energy level!
Therefore, in the future, the EUV lithography machine will choose continuous reflection to adjust the convergence, and finally only have a utilization rate of about 4%, which has extremely high requirements for light source power, reflective materials and precision.

Even Wang Yi cannot overcome all these problems in a short time!

After all, the extreme ultraviolet light of 13.5nm can ionize even the air, and the reflective material itself will have a service life, and the damage of light to the material during use must also be considered.

This kind of high-precision equipment, as long as there is a slight damage, it is enough to cause a world of difference.

Therefore, if overtaking on a curve, Wang Yi had to produce enough material to allow this level of light to pass through!
Originally, at the very beginning, Wang Yi relied on the magical power of the mage tower to prepare for strong pressure, and gradually increased the light transmittance to prove the truth with strength.

But this time, after communicating with this group of mathematicians for so long, it completely opened up new ideas for him!

Just like ASML first relied on the immersion lithography machine to overtake the car in a corner, and then began to study the immersion method at Canon and Connie, and wanted to use the previously accumulated technology to reverse the time limit again. ASML directly opened a new track and made a EUV lithography machine, and opened an insurmountable distance at one time.

Now Wang Yi has completely changed his way of thinking, directly empowering electrons that can absorb light with magic power, forming a certain degree of magic power ionization, and then trying to solve the metallicity brought by free electrons!
Blocking is worse than sparse!

As for how to suppress, the corresponding mathematical model was also obtained through brainstorming during this period.

Even, if this direction continues, in addition to making lenses that can pass extreme ultraviolet rays and even X-rays.

It can also involve a rather scary application area.

Atomic structure changes and fusion reactions!
The essence of fusion is to destroy the atomic structure of low-sequence elements, and the atomic nuclei combine with each other to form new elements.

But the requirements of this process are quite difficult, and it is not of the same order of magnitude as fission. Not only does the destruction of the atomic structure require a lot of energy, but the size of the nucleus is too small compared to the size of the atom itself.

Many people have no specific concept of the difference between the size of the nucleus and the size of the atom.

For example, if the football field is an atom, then the nucleus is only a soybean placed on the center dot of the field, and fusion is to destroy the atomic structure and make the two soybeans in the center of the field collide, so high temperature and high pressure are needed to accelerate the movement. Make sure of this process.

Fusion is known to the hydrogen bomb and the sun.

But the fusion reactions between the two are quite different.

The fusion of the sun is directly completed by our most common hydrogen element 'protium' in an environment with a core temperature exceeding 1500 million degrees and a density exceeding ten times that of lead.

First two protiums are fused into deuterium, then one protium and one deuterium are fused into helium 3, and finally two helium 3s are fused into helium 4 plus two protiums.

The requirements for conditions are far greater than those for hydrogen bombs.

The hydrogen bomb is a simple process of fusing deuterium and tritium into helium 4 plus a neutron. The required conditions are much simpler, and an atomic bomb is enough to detonate.

After Wang Yi studied the new method of interfering electrons with high-energy rays through lenses, he suddenly thought that he would use magic power to disassemble electrons in a 'gentle' way. Theoretically, the difficulty of nuclear fusion would be geometric. reduce!
If the speed and output power of fusion can be well controlled, it can be regarded as cold fusion technology.

"Heh~, if this thing can be made out and taken out directly, I don't know if it will trigger a world war."

After Wang Yi calculated a lot of formulas, he rubbed his forehead.

However, even the lenses are still in the theoretical stage for the time being, and the direct use of protium's polymerization is slowly being done. The difficulty of directly removing electrons and destroying the atomic structure with magic power is much more difficult than pure ionization.

For example, there is metallic hydrogen in the core of Jupiter, but it is still far from the fusion conditions, and even the fusion conditions of brown dwarfs cannot be reached.

But anyway, the direction is already there...

……

After finally working out the prototype of the theory, and the lens research has made some progress, Wang Yi asked Lin Shiqin

"How many biology experts from Umbrella's side have you invited?"

"Four teams have been formed. Relying on the resources exchanged for TT before, we have started research. I will synchronize all the experimental data with you."

Hearing Lin Shiqin's words, Wang Yi was still very satisfied. Employees are highly motivated, which means they can save their own energy.

"Is there any sand?"

"Yes, but not many. This kind of research-oriented talents still prefer to engage in technology. The sand is still placed by our old friends."

"As long as they are willing to do something, then let them do it. I will also send some information from my side to discuss together."

"clear."

The four teams do not contact each other, and occasionally exchange information with each other, and Wang Yi's things are mixed in, so they will only be regarded as the fifth, sixth, or even seven or eight teams.

The test of gene efficacy can also be opened directly!
What Wang Yi can provide them is the magical medium of 'ripening' and 'accelerating'!
This can greatly increase their efficiency...

----

　Fourth update~First update~
　　Now there is only a theoretical direction, and the real thing is still very early, just like the theory of controllable nuclear fusion has come out long ago but has been progressing slowly. The lens is tricky, but it’s just to simplify the steps. There are still quite a few things to overcome.

　　
　
(End of this chapter)